radsecproxy - a generic RADIUS proxy that provides both RADIUS UDP and TCP/TLS (RadSec) transport.
|
radsecproxy [−c configfile] [−d debuglevel] [−f] [−i pidfile] [−p] [−v] |
radsecproxy is a generic RADIUS proxy that in addition to to usual RADIUS UDP transport, also supports TLS (RadSec). The aim is for the proxy to have sufficient features to be flexible, while at the same time to be small, efficient and easy to configure.
The proxy was initially made to be able to deploy RadSec (RADIUS over TLS) so that all RADIUS communication across network links could be done using TLS, without modifying existing RADIUS software. This can be done by running this proxy on the same host as an existing RADIUS server or client, and configure the existing client/server to talk to localhost (the proxy) rather than other clients and servers directly.
There are however other situations where a RADIUS proxy might be useful. Some people deploy RADIUS topologies where they want to route RADIUS messages to the right server. The nodes that do purely routing could be using a proxy. Some people may also wish to deploy a proxy on a site boundary. Since the proxy supports both IPv4 and IPv6, it could also be used to allow communication in cases where some RADIUS nodes use only IPv4 and some only IPv6.
|
−f |
Run in foreground. |
By specifying this option, the proxy will run in foreground mode. That is, it won’t detach. Also all logging will be done to stderr.
−d debuglevel
This specifies the debug level. It must be set to 1, 2, 3, 4 or 5, where 1 logs only serious errors, and 5 logs everything. The default is 2 which logs errors, warnings and a few informational messages.
|
−p |
Pretend |
The proxy reads configuration files and performs initialisation as usual, but exits prior to creating any sockets. It will return different exit codes depending on whether the configuration files are okay. This may be used to verify configuration files, and can be done while another instance is running.
|
−v |
Print version and exit. |
−c configfile
This option allows you to specify which config file to use. This is useful if you want to use a config file that is not in any of the default locations.
−i pidfile
This option tells the proxy to create a PID file with the specified path.
The proxy generally exits on all signals. The exceptions are listed below.
|
SIGHUP |
When logging to
a file, this signal forces a reopen of the log file.
When using TLS or DTLS, reload certificate CRLs.
SIGPIPE
This signal is ignored.
/usr/local/etc/radsecproxy.conf
The default configuration file.
radsecproxy.conf(5), radsecproxy-hash(8)